TWD - Prison Tower (non-splice version)

These instructions are applicable to the following products:

• MM-TWD-PRISON

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

Installation Instructions

1. Remove nut to the left of the right ramp under the backboard. Use two hands as shown in photo.
   
   

2. Remove backing from double sided tape on tower bracket. Install Prison Tower by sliding bracket on top of the screw. Place nut back on screw and start the nut with two hands, then tighten (photo above).
   
   
3. Run wires under bike ramp (left ramp) through to back of playfield. Remove balls and lift play field.
   
   
4. The prison tower mod attaches to the white and red prison flashers. The mod LED colors flash with the opposite color from the games prison flashers (white light flashes with red, red light flashes with white). Locate the two prison flashers using the photo.
   
5. Locate the 3-pin IDC from the games white prison flasher and unplug. Reattach using red and white 3-pin IDC Tower connectors (photo).
   
   
   
   
6. Locate the red prison flasher connection (2-pin IDC) and unplug. Reattach 2 pin IDC connector to mod 2 pin IDC (this installation is the same the one outlined on Step 5).

SERVICE UPDATE: INCORRECT IDC INSTALLATION

Some units have shipped with the red IDC connections backwards. To check for this issues, compare your connections to the photo below. If your unit matches the photo, your connectors are properly installed.

 

If your connectors are opposite direction or the wire placement is swapped, during installation, you will need to turn the connectors around to match the wire colors on the game (black to black, red to red). The wire color from the mod to the game should line up, black to black and red to red.

Copyright Mezel Mods- 2016. All rights reserved. Because stealing is wrong and mean.