Wolverine LE Bracket

 

DANGER ELECTRICAL SHOCK

Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.

Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.

Images included in these instructions are of an installed prototype and may vary from your product slightly.

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

Installation Instructions

1. Remove the right pop bumper plastic that sits behind Wolverine. Remove Wolverine by taking out the two screws in the back.
   
   
   
   
2. Install the belt onto the figure and cut out the bottom using the belt hole as a template. Utilize an exactor or other sharp knife.
   
   
   
   
3. Attach the angle shim by screwing in the short screw into the upper hole. Make sure the bottom two screws line up then lock in the top screw.
   
   
   
   
4. Carefully install by lowering Wolverine and use the supplied screws to attach him. The lowest screw is a tad hard to get to so you will need to manually lower the pop bumper bracket to access it with a screwdriver. He should now face the magnet core.
   
   
   

Copyright Mezel Mods- 2016. All rights reserved. Because stealing is wrong and mean.