Amp Pro/Prem/LE Versions

 

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

Note: You will need a set of basic pliers for attaching splice connectors

Splice Connector Tutorial

The splice connector uses a clamping metal blade to lock down on two wires, creating a single connection point without the need to solder.
The terminal slot is the top hole shown in the photo (labeled tower wire) and is used for the wire from your mod. You’ll notice this slot has a terminal point inside which does not allow the wire to feed all the way through (terminal slot). The run slot is the bottom hole shown in the photo and is for the wire you’ll be connecting to in your game. You’ll notice that the run slot is open all the way through.

To ensure your wire on the top is fed all the way to the terminal point, feed the mod wire into the terminal slot and mark it on the outside using a marker. This will prevent you from closing the splice connector without making a connection.

 

To make the connection, utilize pliers to carefully push the metal blade down into connector. Close plastic bracket around splice connector.

 

DO NOT close plastic bracket until after pushing in metal piece with pliers.

Installation Steps

1. For Pro version: Remove the second screw on the right front of the Star plastic using a Philips head screwdriver and needle nose pliers (to hold the hex post from underneath the plastic). For Pro version, continue to step 4.
   
   
2. For PREMIUM/LE VERSION ONLY. Unscrew the post from the back of Paul's back. Next, remove all screws on the Star plastic and take plastic out of game. 
   
   
   
   
3. PREMIUM/LE VERSION ONLY. After removing plastic, remove the existing amp and retain two of the screws. Utilize the screws to attach the new solenoid cover (as shown). Replace the Star plastic feeding post back through solenoid cover. Reattach post to Paul's back and proceed to step 4.
   
   
   
   
4. Slide the screw through the speaker bracket and attach to Star plastic, again using a Philips head screwdriver and needle nose pliers (to hold the hex post from underneath the plastic). Tighten firmly but do not over tighten.
   
   
   
   
5. Feed wires down to the left of the Star plastic as shown. Guide the wires down through the hole in the playfield under the second plastic.
   
     
   
   
6. Lift the playfield and pull the wire completely through until snug (photo shows wire exiting the hole in the playfield).
   
   
7. Locate the Kiss pop bumper flasher lamp board (and attach the wires using the splice connectors (see tutorial on page 1) connecting the black speaker wire to the orange game wire and the red speaker wire to the red game wire.
   
   

Copyright Mezel Mods- 2016. All rights reserved. Because stealing is wrong and mean.