DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
- Turn off power. Use an 1/4" hex driver to remove the acrylic reflector piece from the backboard. This piece is not used in final installation.
Attach wire harness clip with 3M tape to metal bracket behind Stay Puft.
Lift playfield onto service rails. Attach second wire harness clip using existing hardware to right rear corner of backboard playfield bracket as shown.
- PKE Illumination attaches to the backboard and can be placed as high as player desires. Determine desired height prior to attaching ensuring PKE is visible for player. Once height is determined, align ‘K’ on playfield to ‘K’ on mod and attach to backboard. Attach PKE to backboard using 3m tape.
- Slide LEDs into PKE Illumination bracket and feed wiring harness through wire harness clips. Lift playfield.
- Locate the 6 Lamp board in the bottom left corner of the playfield. Unplug the 12-pin connector C1 and re-attach using jumper wire harness.Ensure you the black wire is in the far left position when connecting to the board and the blue wires on the games connector are on the left side.
Utilize additional zip ties to attach harness to playfield wiring harness. Installation is complete!