These instructions are applicable to the following products:
DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
- Turn off game and remove glass from playfield.
- Pull out playfield on to service rails. To protect cabinet sides we recommend using our cabinet assembly protectors.
- Lift up playfield. Unplug pictured plug from cabinet.
- Feed factory plug as far as it can go into cut out on playfield.
- Lower playfield. Unscrew bottom two screws from factory tower and place to the side for step # 6. Remove factory tower and pull wire all the way out. NOTE: Wire can be difficult to pull out, we recommend maneuvering plug through circled area.
- Remove factory tower. Put in a safe space for reinstallation.
- Feed mod plug into cutout on playfield underneath ramp. This can be difficult. If necessary, position mod plug into hole first then push the wire through.
- Lift Playfield. Plug mod into game.
- Lower playfield. Screw in Mod Tower with screws from step #4.
- Unscrew roof from factory tower. Cut factory bell off.
- Secure to Mod Tower Roof using provided zip tie.
- Remove backing from tape on top of tower and place roof into cut outs.
- Remove backing from tape on entrance and place over screws.
- Finished!
Comments
0 comments
Please sign in to leave a comment.