Pawn Shop

These instructions are applicable to the following products:

• MM-PULP-PAWN and link to product page

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

1. Turn off game. Remove glass from playfield.
2. Unscrew nut from right side of back of factory shop. Put to the side for step #X.
3. Unscrew screw from left side of factory shop. Put to the side for step #X.
4. Unscrew 'Pawn Shop' acrylic from face of shop.
5. Unscrew black plastic from factory shop. Remove screw, spacer, and nut and place in a safe space. Repeat on other side.
6. Unscrew PCB Board from factory shop.
7. Remove lights and board from factory shop.
8. Place tape onto PCB board and black plastic.
9. Move wires around acrylic to keep them out of the way.
10. IMPORTANT - Screw right side of mod on first. Keep nut loose.
11. Removing tape backing from PCB Board and place into cut out on mod. Hold for 30 seconds. 
12. Screw in left side of mod. Tighten nut on right side. (NOTE: Tolerance is very tight once mod is in place. We recommend using pliers to tighten nut.)
13. Remove backing of tape on black plastic. Place onto underside of roof as shown.
14. Place lights into cutouts on mod.
15. Slide roof onto mod. Finished!