GOZ - 70th Anniversary Kaiju Scoop Sign

These instructions are applicable to the following products:

• MM-GOZ70-KAIJU-SIGN

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

1. Turn off game. Remove glass from playfield.
2. Identify scoop on the right side of the machine and apply long tape as shown in picture.
3. Following the wiring for the spotlight behind the sign, fish the Kaiju connector through the same hole.
4. Use extreme caution on the LED. While the LEDs are durable to weather and such, they cannot take a pull. We've snapped many COB LEDs if we aren't paying attention.  Also using the wiring from the spotlight, ziptie the mod wires to the spotlight. Our goal is to get enough tension on the LED so they look good on the sides of the sign. Again, be gentle yet firm.
5. Raise the playfield. Be sure to shove something in the ball launch so you don't have balls tumbling down everywhere.
6. Identify the global illumination bulb in the image and replace with the provided bulb. 
7. Attach reverser to the connector from the bulb and the connector from the mod. 
8. Remove whatever you shoved in the ball launcher and you're good to go!