RFM - Stroke of Luck Hole V2

These instructions are applicable to the following products:

• MM-SCOOP-GRN

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

1. Turn off power and lift playfield. Locate underside of Stroke of Luck Hole. See arrow on image.
2. Using the tape provided secure the LED board to the scoop. The best place for the LED board is on the right side of the scoop. An image has been provided with some additional tips.
3. To power the LED board, you will need to find a #44 bulb located in the game. A page from the Revenge from Mars service manual showing the location of all of the #44 bulbs has been provided below. We recommend removing the bulb located at either 62A or 63A as those are the closest to the scoop. This will require you to unscrew the bulb socket and removing the bulb located at 62A or 63A and then replacing it with the matrix bulb provided. A closeup of area where 62A and 63A are located has been provided below. A list has also been provided showing all of the #44 and #555 bulbs located in the game. 

Using the provided zip tie, tie the illumination into the wiring harness. 

Lower playfield. Installation is complete!