DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
- Remove the screws at the entrance of the right ramp. Place screw through holes in base of arch and replace screws.
- Remove the screw in the acrylic above the drop targets. This will make feeding the wire through easier.
- Feed the wires through the hole in the playfield that lies behind the drop targets. It is the same hole the spotlight wires feed through. You can trace the the spotlight wires to find this hole. The picture is from under the play field. Using the 1' section of wire may make this easier.
- Disconnect the 3 pin IDC labeled CN5 and replace with our jumper. Place the OEM flasher IDC on the other end of our jumper.