Pinball Scoop- TZ

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

NOTE: This product requires the replacement of one of your stock GI bulbs with a frosted white dome bulb. For best results, we recommend selecting a replacement location that is hidden below a playfield plastic. If you prefer not to utilize the replacement bulb, a set of alligator clips can be utilized instead. Please note that alligator clips are not intended for permanent connections and can come loose potentially causing shorts.

Scoop illumination can only be installed on 6v sources; 12v sources will cause the board to be blown. Utilize General Illumination sources or consult your games manual to find alternative 6v sources.

1. Power off the game. Remove glass and pinballs. Lift the playfield.
2. Locate your games scoop or vertical upkick (VUK) mechanism. 
3. Attach the LED board to the outside left of the scoop hole such that the LED shines into the scoop. Some experimentation may be necessary to achieve the desired illumination in your game.
    
4. Locate a GI bulb in your game that is located under a playfield plastic (please see our NOTE above if your game has the wedge style GI or you prefer not to replace the bulb, please utilize the alligator clips). Remove the desired GI bayonet and replace with the Matrix bulb provided with the product. Adjust frosted dome of bulb so it is close to the top of the bayonet. Reattach bayonet to playfied ensuring connector is accessible from bottom of playfield. Alligator clips should be attached to both sides of the bayonet or wedge socket.
    
5. Attach Matrix bulb connector to LED connector as shown.
    
6. Lower playfield and turn on game to test functionality and ensure proper illumination. Adjust as necessary.
7. Installation is complete!
    

Copyright Mezel Mods- 2018. All rights reserved. Because stealing is wrong and mean.