These instructions are applicable to the following products:
- MM-BACKBOARD-JJP-RGB
______________________________________________
DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
- Turn off the power, remove the glass and balls from the game. Lift the playfield onto the service rails so you can access the bottom of the backbox.
- POWER CONNECTION: Install the JJP Fused Power Tap.
- Attach the LED strip to one of the 2-way connectors on the white RGB Control Box. Attach the LED strip so that the black wire is in line with the arrow on the connector.
- Connect the wiring harness to the other end of the RGB Control Box. This end is then connected in to the JJP Power Adapter installed in step 2.
- Turn power back on to the game and test the LED using the remote included with the controller box.
- Mount the RGB controller box inside the backbox and feed the RGB LED strip down through the opening in the left side of the backbox to the playfield.
- Attach the LED strip to one of the 2-way connectors on the white RGB Control Box. Attach the LED strip so that the black wire is in line with the arrow on the connector.
- LED INSTALL:
- Locate the wooden runner (long narrow piece of wood that runs under the backbox above where the glass slides in).
- Using the tape provided, attach the LED strip to either the bottom side of this piece (so light points downward onto the playfield) or on the side perpendicular to the backbox (so the strip shines directly on the back panel). We recommend this determination be made while the game is on so the LED can be tested in the two positions prior to attaching permanently.
- Replace the playfield and glass- installation is complete!
- Installation is complete!
Comments
0 comments
Please sign in to leave a comment.