Godzilla Noodle Building

These instructions are applicable to the following products:

• MM-GOZ-NOODLE-BLD
• MM-GOZ70-NOODLE-BLD

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

1. Pull playfield out to where rubber stoppers are resting on front edge of cabinet.

2. It is easiest to prop up the playfield using the instructions below to provide for easy access to the Side of the Noodle building to unscrew the factory building (step 4) however it is not required. This makes the process a bit easier.

Prop up playfield with a piece of 2x4 plywood in order to lift back end of playfield up. Make sure plywood is propping up area of playfield without any assemblies as to avoid damage. Playfield should be high enough up to be parallel to ground. FOR REFERENCE: This particular piece of wood was 19" and worked perfectly.

3. Unscrew middle three screws from noodle bar signs. Use pliers to hold nuts on back of LEDs while unscrewing. Save screws, nuts, and spacers in a safe space for reinstallation of factory parts. When removing screws place hand underneath to catch falling spacers.

4. Unscrew three screws holding in factory installed building and set them to the side for next step. Unplug sign wire assembly from behind playfield. Remove building from playfield.

5. Using pliers as an anchor, remove final two sign screws. Remove LED Assembly from sign acrylic and set aside for step 6. Place factory acrylic and building in a safe space for future reinstallation.

5. Align Noodle building onto brackets. Screw in front facing screw first, followed by side screws. Do NOT screw side screws too tight. NOTE: Some games might come with uneven brackets and may need to be adjusted in order to line up with mod.

6. Remove red backing from adhesive on Noodle Sign. Place individual LED boards into cutouts on back, holding each board in place for about 30 seconds to ensure good adhesion. 

7. Cut large tape enclosed into two small pieces, around 5mm each. Place pieces onto round pegs on right side of building.

8. Remove red backing and gently feed LED assembly through cutout into back of playfield. Mount sign onto building, holding in place for about 30 seconds.

9. Plug wire assembly back into game.