DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
1. Turn off game and remove glass.
2. Place two pieces of tape on either side of factory sign, with a little bit hanging off the edge. Remove backing from other side.
3. Place Mod Sign over factory sign, aligning the bulb within the gear of the mod.
4. Hold for about ten seconds to ensure adhesion.
5. Pull wire on righthand sign to back of mod and clip in place using hook on mod.
6. Finished!
Comments
1 comment
think you need to make room for the screws the tape didn't work i had to add a few pieces to build it up so it would stick on the left side also had to put one on the top as well.. looks much better thanks
Please sign in to leave a comment.