These instructions are applicable to the following products:
- MM-RNM-ANATSIGN
DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall them by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
1. Remove glass and pinballs. Place assembly protectors on sides of cabinets.
2. Unscrew top left factory screw on left ramp.
4. Place screw into mod.
5. Screw mod back into place.
6. Lift up playfield. Plug .4 pin IDC into connector shown. NOTE: DO NOT INSTALL IN ANY OTHER LOCATION AS THIS CAN CAUSE DAMAGE TO GAME.
7. Snake molex wire through cutout pictured. Connector should come out from underneath Noob Noob plastic.
8. Connect wire to mod.
9. Finished!
Comments
0 comments
Please sign in to leave a comment.