These instructions are applicable to the following products:
- MM-TS4-CARNGAME
DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact usfor assistance.
When removing screws from the playfield, reinstall them by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
You'll need a screwdriver and pliers
Lift the Playfield up and out just far enough that the "Lumber Snacks" is accessible
Locate the 4 bolts holding it on then use the pliers to hold the nut still and unscrew the bolt, hold on to the bolts and nuts to install the new mod
Remove the "Lumber Snacks" and place the new mod in its place
Reinstall 3 of the 4 bolts and then you're ready to go
Comments
0 comments
Please sign in to leave a comment.