KISS - Backbox Illumination

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

You can also view our installation video for this product here.

NOTE: DOUBLE SIDED TAPE IS VERY STRONG. BE SURE TO MEASURE CAREFULLY PRIOR TO AFFIXING. REMOVING FRAME FROM BACKBOX CAN BREAK THE KISS LETTER FRAME.

1. Remove the backglass and set aside. Attach double sided tape to the top of the inside lip of the backbox*. Carefully slide the Kiss backbox frame on the inside lip until the 'I' is positioned 1/4" to the left of the key (have key in perpendicular position when measuring). Press the frame down on to the double sided tape.
   
   
   
   *if you backbox kit shipped with the tape already affixed, measure placement,  remove tape backing and carefully slide the backbox frame into place.
   
   
   
   
2. Run wire harness through hole in bottom of backbox down into cabinet. Lift playfield.
   
   
3. Remove the 12-pin connector from the lower left, bottom most node board (the board closest to the inside bottom of the cabinet). Utilize the wiring harness to attach the backbox kit to the board. Position the 12-pin connector on the board. Attach the other side of the harness (with the 12-pin white z connector) to the 12-pin connector wiring.
   
   

Installation is complete!

Copyright Mezel Mods- 2016. All rights reserved. Because stealing is wrong and mean.