MBR - Frankenstein's Monster Table

These instructions are applicable to the following products:

• MM-MB-FRANKS-TABLE 

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

1. Attach tape as shown in photo below: 
   
2. Remove tape backing from the backside of table mod. Place to the side (within reach) with tape facing up.
3. Lift Frankenstein's monster so that the wire switch and the monster no longer touch.
4. Slide the table mod between the monster and mechanism. Be sure that the wire switch is in the slot on the table. Press down firmly and allow the monster to rest on the table.