DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly. Color of LED bracket may vary but does not impact product performance or installation.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
NOTE: This product requires use of a 3-pin Molex power adapter with 'standard polarity', with power in flat side of connector and ground in pointed side. This product is not compatible with the JJP topper connector.
- Turn off the game, remove the playfield glass and lift playfield.
- Locate the solenoid below the playfield hole you wish to illuminate. The photo below shows the solenoid below the Throne Room in Wizard of Oz.
Magnified view of hole (below) shows solenoid, bracket, and opto (white board).
- Remove backing from adhesive on LED bracket and attach to metal hole bracket. Place bracket in a location that it will provide optimal lighting without LED visibility from the top of the playfield. Photos show installation on WOZ Throne Room.
- Run wiring harness along underside of playfield to backbox. Install using Mezel Mods JJP Power Adapter
Comments
0 comments
Please sign in to leave a comment.