JJP Power Adapter (Fused Power Tap)

These instructions are applicable to the following products:

• MM-POWER-ADAPTER-JJP

WHATS IN THE BOX

Fused power adapter with a 2pin .093 jumper to a 3pin .093 receptacle

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

This product is designed for use with  3-pin Molex and 'standard polarity', with power in flat side of connector and ground in pointed side. This product is not compatible with the JJP topper connector.

1. Turn off game, open the backbox and locate the backglass LED strip; follow the wiring down to the white 2 pin in-line connections.
   (shown on DI- first photo, POTC second, GNR third photo; Wonka not shown but connection point is the same).
      
   
   
2. Unplug and attach JJP fused jumper connection as shown.
    
3. Run wiring with 3 pin molex plug along the bottom of the backbox and down into hole in cabinet as shown.
   
4. Remove glass and lift the playfield. You will see wiring hanging into the cabinet. Attach either your desired 12v product or attach one of our expansion options (3-way splitter or deluxe splitter- shown).