

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
- Turn off game. Remove glass from game and set in a safe and secure location.
- If you have gameblades/ art blades, Place the Pinball Cabinet Assembly Protectors on each side of the machine. Next remove the pinballs from the trough. Then lift the playfield into the upright position.
- Locate the fuel target section. Remove the #44 Red bulb and replace it with the one provided. It should have the 6" matrix wire attached to the end of it. If not, place that connection on the end of it. Once completed, the area should look like the image below.
- Remove the two screws that hold the metal plate in place, place the bracket provided on top of the metal plate and then rescrew the screws back into place. When done correctly, the area should look like the image below.
- Attach the splitter to the 6" matrix wire. A zip tie has been provided so that the wire can attach to the wiring harness. An image has been provided showing where to place the ziptie.
- Install done! Enjoy the Fuel illumination.
Comments
0 comments
Please sign in to leave a comment.