DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
NOTE: PHOTOS FOR THESE INSTALLATION INSTRUCTIONS WERE TAKEN ON DIALED IN. GAME TO GAME DIFFERENCES WILL OCCUR.
This product is designed for use with 3-pin Molex and 'standard polarity', with power in flat side of connector and ground in pointed side. This product is not compatible with the JJP topper connector.
- Turn off game and locate the backglass LED power (shown on DI- first photo, POTC second, GNR third photo; Wonka not shown but connection point is the same).
- Unplug and attach JJP fused jumper connection as shown.
- Run wiring with 3 pin molex plug along the bottom of the backbox and down into hole in cabinet as shown.
- Remove glass and lift the playfield. You will see wiring hanging into the cabinet. Attach either your desired 12v product or attach one of our expansion options (3-way splitter or deluxe splitter- shown).