Bearcade

Vendor's Website(External Link)

Products:

Beer Can

USA Flag

Life Ring

Buoy

Dive Light

Orca

Orca Dive Light

Beach Closed

 

 

JAWS Beer Can

1. Locate factory plastic #19 and use a Philips Screwdriver to remove the two screws which hold the 2 posts in place
2. Leave the Stern-plastic untouched, it shall remain in its position.
3. Put the Beercan mod on top of and use the two previously removed screws to attach the black bracket of the Mod.
4. Carefully tighten the screws.

JAWS PRO USA Flag

1. Remove flag from packaging. 
2. Either glue or tape flag behind the plastic houses in the back left corner of the machine or place flag on posts above the drop targets. 

Jaws Life Ring

1. Remove lockdown bar from the machine and remove pinball glass so it doesn't slide off the machine. 
2. Take a set of channellock Tongue and Groove Pliers and unscrew the silver bracket holding the action button on the lockdown bar. 
3. On the lockdown bar and on the bottom of the life ring is a guide. Place life ring into the grove on the lockdown bar. 
4. Once the life ring has been added, then place the button into the life ring and then rescrew the action button into place. 

Jaws Buoy

1. Remove the lockdown bar and remove the glass from the machine. Place the glass in a secure location so that it doesn't break. 
2. Underneath Quint's shack is a nut that holds the back left plastic in place. The nut is circled in the image below. Remove this nut and place in a secure location.

3. Place Buoy on screw post and reattach nut to the location. 

Jaws Dive Light

Please utilize the Bearcade video on how to install either version of the Dive Light

All Other Jaws Mods

For Oraca Lamp, Orca boat, Beach Closed, Wave mods see attachments below.