007 - Underwater Illumination Kit

These instructions are applicable to the following products:

• MM-007-UNDERWATERILLUM-GRN+BLU

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

Setup:

Remove the glass and then lift the playfield up and out. Don't forget to secure the pinballs with something or remove them and use cabinet protectors (sold separately) to prevent any damage.

Locate the underwater battle acrylic (shown below)

Install:

Part reference:

MM-007-UNDERWATERILLUM-GRN+BLU

Tools required:

Flathead Screwdriver

1/4 Wrench (recommended)

Remove the factory light with the wrench (recommended) or the flathead (not recommended at this time), when the metal bracket is loose you can rotate it 180 degrees and use the wrench on the other side to make the removal easier. (shown below) Save the factory screw in a safe place for installation later.

Remove the light insert by pushing down and turning, and install the new mod by repeating those steps in reverse. 

Place the factory screw back in the metal bracket first then the plastic bracket after. There are 3 mounting points on the plastic bracket, this is for variants in the factory screw hole. There's no right choice just some trial and error testing, pick your favorite look because there's little difference.

Screw the brackets back on with the flathead screwdriver, and you're all done.