007 - Rocket Replacement

These instructions are applicable to the following products:

• MM-007-ROCKET

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

Setup:

Remove the glass and then lift the playfield up and out. Don't forget to secure the pinballs with something or remove them and use cabinet protectors (sold separately) to prevent any damage.

Locate the rocket's bolt (shown below)

Install:

Part reference:

MM-007-ROCKET

Tools required:

3/8 Wrench

Hold the rocket with one hand (recommend gripping the o-rings) and then use the wrench to unscrew the bolt.

With the rocket removed, save the washer and bolt in a safe location, and then roll the black o-rings off (one at a time will be the easiest way).

Take your new mod and stretch then roll the o-rings on from the bottom.

Hold the new rocket with one hand, gripping it from only the o-rings, and then use the wrench to screw the bolt. Note: however you're holding the rocket, that will be the way the rocket faces. Recommend that you hand tighten the bolt a little, then spin the rocket into the orientation you prefer then use the wrench to screw it in the rest.

Important note: the new rocket has a nylon lock-nut, when you screw it in it will be easy at first then it will grip the nylon and get harder to screw in. Push past that nylon and keep screwing in the bolt until you feel the bolt grip again, now give the wrench another 1/4 turn and you're all set.

You're all done! Hope you enjoy your new Rocket.