CC - Bullet Post Cover

DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts. 

Please follow these safety instructions as well as all installation instructions.  Failure to follow these instructions may result in damage to the pinball machine, accessory, or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation. 

Images included in these instructions are of an installed prototype and may vary from your product slightly. 

If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.

When removing screws from the playfield, reinstall them by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.

NOTE: Installation will be very similar for the left playfield post.

1. Hardware Needed

• 11/32" Socket (1/4)
• Needlenose  Pliers

2. Remove 8-32 Nylon-hex nut and washers

Use a ratchet with a 11/32" socket to remove the factory 8-32 nut and washers, - store in a safe place until installation is complete.

3. Carefully lift plastic ramp to sufficient height to install mod

Rotate Bullet mod until the recessed surface is positioned under ramp mounting point as shown. 

4. Slide Bullet Shells on post and position the ramp on original mounting spots

5. Using thru-hole on Silver Bullet Caps piece, position on threaded post, as shown. 

The silver extruded feature should mate with the similar feature on the gold piece 

6. Reinstall 8-32 nylon-nut 

Using 11/32" socket, tighten and torque down lightly. 

DO NOT OVERTIGHTEN NUT.  The nut should be more than finger tight. 

7. Place Center Cap over nylon-nut and installation is complete.