DANGER ELECTRICAL SHOCK
Pinball machines have high voltages which can cause DANGER TO LIFE AND LIMB. TURN POWER OFF and UNPLUG PINBALL MACHINE prior to installation. Pinball machines are high voltage and can cause electrical shock.
SAFETY GLASSES are also recommended while working with or installing pinball parts.
Please follow these safety instructions as well as all installation instructions. Failure to follow these instructions may result in damage to the pinball machine, accessory or other parts. Please see our Disclaimer for associated risks and responsibilities (Section 13 in our Terms of Service) prior to installation.
Images included in these instructions are of an installed prototype and may vary from your product slightly.
If you have questions or concerns regarding the proper installation of this part, please contact us for assistance.
When removing screws from the playfield, reinstall by first turning them counter-clockwise to match the original groove in order to respect the integrity of the playfield wood.
- Turn off game and remove glass from playfield.
- Pull out playfield on to service rails. To protect cabinet sides we recommend using our cabinet assembly protectors.
- Remove screws from top of Factory Building. Put aside for Step #11
- Lift up Factory building and anchor nut under LED board. Remove screw from top. Place Factory Building, Mini Dome, and screw in a safe place for future reinstallation.
- Push LED board through hole pictured.
- Locate MINIFIT plug on underside of upper playfield.
- Using one hang, grab plugs and push up against the playfield. Use this to anchor the plug while unclipping the LED assembly.
- Pull out assembly. Keep in a safe space for future reinstallation.
- Locate playfield plug. Push plug up against upper playfield and plug in Mod assembly.
- Feed Matrix plug through hole in upper playfield.
- Take screws from Step #3 and screw Mod building onto bracket.
- Plug Mod into assembly wire.
- Remove backing from tape on bottom of roof. Place on top of building and hold for 10 seconds to ensure adhesion. Finished!
Comments
0 comments
Please sign in to leave a comment.